VLAN Membership Methods
VLANs can be assigned to switch ports either statically or dynamically.
Static Assignment
Membership is port based. Switch ports are statically configured for specific VLAN. End-user devices are not aware if a VLAN exits. Configuration is also very simple. A single command assigns the port to specific VLAN.
Warning: A port can be configured to one VLAN at a time. Both standard and extended range VLAN is supported but extended VLAN are not propagated by VTP and are only available if a switch is configured in VTP transparent mode. Newer Catalyst IOS releases allow creation of VLAN(s) on the fly. Previous versions required to create VLAN(s) in VLAN database and then assign ports to specific VLAN(s).
Step-1: configure terminal
Step-2: interface [range]
Step-3: switchport mode access
Step-4: switchport access vlan
Step-5: end
Verification: show vlan brief
Dynamic Assignment
Membership is based on MAC address of an end user device. When a device is connected to switch port, query must be made to establish VLAN membership. The MAC address to VLAN mapping is managed by central database namely: VLAN Membership Policy Server (VMPS). Typically Cisco Works is required to manage the dynamic assignment of VLANs.
Configuration
Configuration is done in two steps. First specify the VMPS. Configure switch ports for dynamic assignment.
VMPS:
Step-1: configure terminal
Step-2: vpms server [primary]
Step-3: end
Verification: show vmps
Port Assignment for Dynamic VLANs
Step-1: interface
Step-2: switchport mode access
Step-3: switchport access vlan dynamic
Step-4: end
Verification: show vlan brief